Skip to main content

5 replies

Kline semi scale hudson - help!

MW mike wOGR Forum Member

Hi Everyone,

 

The engine in question is a semi-scale ATSF model number K320-3462s

 

I bought 3 K Line engines ages ago when I first started a layout - didn't have command then so have only ever run this engine in conventional. It has been under the layout for ever but was "rediscovered" today.

 

It wont run. I apply power and I get Lights all round but no movement or sounds although you do get an electrical noise from the speaker.

 

I have no instruction manual - can anyone tell me how to do a reset and what number to key in please?

 

Is the arial in the tender as well? as there is a wire gojng up into the removable top piece where there  is a handrail?

 

I have looked in the tender nothing obviously amiss - check all connections, no broken wires. Engine will not run on its own - I assume I need the tender.

 

Any ideas/suggestions are most welcome as I live in England so finding anything out over here is a complete no no!

 

I appreciate this is probably a bit of a highbrid with very early rail sounds

 

Thanks

 

MIKE

 

 

Original Post

Replies sorted oldest to newest

N NortonOGR Forum Member

Mike, Best bet is to reprogram it. It probably has been assigned a number other than 1.

 

Put the engine in Program mode.

hit Eng xx Set (xx=the number you want your engine to be) (whistle should sound)

then hit Aux1 4 (4=steam engine with smoke) (whistle should sound again)

 

Turn off the power and put the engine back in Run mode.

 

 

Pete

 

 

Add Reply

Views: 410
Post

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×

Access to this requires an OGR Forum Supporting Membership

OGR Forum Supporting Membership

Help support this forum with an OGR Forum Supporting Membership.
You will be able to watch the videos in the INSTRUCTIONAL VIDEO FORUM!
A one-year OGR Forum Supporting Membership is only $12 per year, so sign up now!


    OR     


Access the ALL the OGR VIDEO FORUMS AND  over 300 back issues of OGR
with a DIGITAL SUBSCRIPTION!



$12.00 per 12 Months (plus tax if applicable)
×