I have a new Legacy Dreyfuss Hudson that I run with Legacy through my CAB2. For some reason the whistle randomly blows on its own. Any ideas as to the cause would be appreciated.
Original Post
Replies sorted oldest to newest
Are you in sequence mode?
https://www.lionelsupport.com/...uss%20Hudson_web.pdf
page 20
LEGACY RailSounds Sequence Control
Your LEGACY-equipped locomotive features Sequence Control. Based on the movement and
speed of the locomotive, Sequence Control automatically plays the sound effects of an entire trip,
from departure to destination, while you run your locomotive. Prototypical horn signals, bell, and
radio chatter are added automatically as you spin your throttle—no need to memorize a sequence of
button presses.
To activate the Sequence Control feature, press and hold the AUX1 button for three
seconds. You'll hear a unique bell/horn signal, indicating that Sequence Control is now
enabled. Release the AUX1 key when you hear the sound.
Now, radio chatter, air brake release, and warning signals will play automatically as you
move out, reach cruising speed, and then decelerate for arrival, as illustrated in Figure 9. Plus,
you can still activate CrewTalk announcements using your remote.
To discontinue Sequence Control, you must tap AUX1, and then tap the 0 key or the
RESET button. Cycling track power off and back on also turns off Sequence Control mode.
Vernon, I did a reset with the CAB2, but it still blows at will. I've never had this happen with a Legacy engine before.
@BradFish1 posted:Vernon, I did a reset with the CAB2, but it still blows at will. I've never had this happen with a Legacy engine before.
It's a new product under warranty- call Lionel.
It turns out that the whistle slider on my CAB2 is hanging up a bit.
SEE AI at it again!
