I installed through the black module on my Legacy Cab 2 the upgrade 1.5 today. The install went well. I ran my Polar Ice legacy engine around and decided to do a record, and playback. The record went well, but when I went to play back the record, the engine did not respond and irradically went into reverse causing a mild derail, of which my lockon kicked the power off. Now when power is applied to locomotive it causes a short, and no matter what status I switch to locomotive to (program or run) it goes in reverse and trips the (lockon --- breaker). I switched it to conventional mode and will only go in reverse. Is there some way to reset, or do I have a major issue here? Can't figure out what caused this to happen. I can't get it to sit on the tracks long enough for my Legacy to power up. Its a new legacy engine (Christmas). Do I need to visit Canfield?
Original Post
