Legacy/Command Base Connection

The posts that were on the CB apparently backed out when someone removed something. Unless you look closely, the threads will match the the original threads on the end of the cable hood.

Hi Chuck

I see what you have described. I have an additional command base connector, with two screws. But the problem seems to be that the Legacy cable is a Male connector and the 'hood' is a male connector. 

Seems I need something that is male into the base and female on the other side to accept the Legacy cable.

Sounds odd, must have something to do with the DataDriver. I'll keep looking in my 'parts box' and at the data driver.

Ralph

I think this is what I need. It might be called a shoulder bolt. Male on one end, female on the other.  Anyone know where I can obtain two of these?

Thanks

Ralph

They are called stand off screws and you can get them at a computer store.

Have you looked at the plug on the cable that was previously attached to your CB?  They may be on that, as these screws have a habit of staying attached to anything that was screwed into them.

Looked everywhere here but found nada. Located them - thanks for giving me the name of these things - on McMaster Carr.  Metric is a bit pricey - That will teach me to be more careful.

thanks for the help

Ralph