Skip to main content

2 replies

Lionel Legacy system compatiblity with DCC?

RobbinRobbinOGR Forum Member SUPPORTING MEMBERDIGITAL SUBSCRIBER

Hi folks

very new to O gauge so pardon the basic question.

I would like to run a Lionel legacy system steam engine (EM-1) with a DCC system .  I have nothing except normal AC transformers at this point for three rail operation but was looking to use DCC for the layout that is being built.  Dont have any Lionel legacy controller either.  Just the loco.  Would be converting other locos to DCC with decoders and adding sound in some cases.

Suggestions would be very welcome!  Thanks!

Last edited by Robbin
Original Post

Replies sorted oldest to newest

Add Reply

Views: 417
Post

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×

Access to this requires an OGR Forum Supporting Membership

OGR Forum Supporting Membership

Help support this forum with an OGR Forum Supporting Membership.
You will be able to watch the videos in the INSTRUCTIONAL VIDEO FORUM!
A one-year OGR Forum Supporting Membership is only $12 per year, so sign up now!


    OR     


Access the ALL the OGR VIDEO FORUMS AND  over 300 back issues of OGR
with a DIGITAL SUBSCRIPTION!



$12.00 per 12 Months (plus tax if applicable)
×