Ok I need some help, is there some trick to making a TMCC crane operate with legacy remote? The dial rotates the crane but when I it Aux 1 and boost not only does the boom move but the crane rotates without turning the dial. Basically I need some help with this. Or does this only operate with a Cab 1? Thanks
Replies sorted oldest to newest
There are provisions in the legacy remote for a crane car. If you programmed it correctly you should have a keypad full of icons specifically for the crane car.
Mine works great with the Legacy remote, I've never seen this issue.
I've had problems before where I think it was the Legacy forgot the cranes programming ID, or the crane forgot its own ID number. I can't remember now how Lionel had explained it, but about once a year I need to dig out the email Lionel sent me and go through the steps to reprogram the crane into the Legacy remote. When it is programmed I get the icons on the key pad just as Gunrunnerjohn posted above. Maybe you could try to reprogram your crane too?
Sam
Access to this requires an OGR Forum Supporting Membership
