The headlight and cab lights are blinking like it's not receiving the tmcc signal. It has been reset with no improvement, cleaned all wheels, rollers, etc. it does seem to run better in reverse than forward but not much. Any ideas?
Dave
Replies sorted oldest to newest
Top suspect would be either the antenna disconnected or the R2LC is dying.
Did you inadvertently start the stall setting?
J Daddy posted:Did you inadvertently start the stall setting?
I don't think so but I will check.
Dave
What is the "stall setting?" I'm having the same problem. Lights, startup sounds, then automatic shutdown on three TMCC engines which operated ok prior. Neither of 2 cab1s make any difference.
Stu
David,
On start up, press the set button twice about a second apart. It takes out any stall setting you might have done. As for the blinking light, check the antenna wire inside and make sure it is not touching any metal.
See you next week at York.
Ted
Access to this requires an OGR Forum Supporting Membership
