My question is, If I have two loops of 3 rail track, Inner and outer loops and they are connected together with 2 switches so I can get the train from inner to outer loop. I'm using 1 channel from the TIU for the outer loop and a second channel for the inner loop. Should the crossover switches be isolated at just the center rail or all three rails? Each TIU channel is powered by a separate z1000 brick.
Thanks Chris
Replies sorted oldest to newest
Chris,
Should the crossover switches be isolated at just the center rail or all three rails?
It's only necessary to isolate the center rail.
 | This and a whole lot more is all in “The DCS Companion 3rd Edition!" This book is available from many fine OGR advertisers and forum sponsors, or as an eBook or a printed book at OGR’s web store! |
Thanks Barry. I wasn't sure if it still worked the same as a conventionally controlled layout. Yes I must order a copy for myself!
Chris
I am set up exactly like Chris is. The only difference is I have two TIU's for four mainlines and all are isolated from the other through the center rail. I ran a test for signal strength and got 10's on three of the mains but the fourth I am having trouble with. But my question goes back to the first two mainlines. If I have a DCS engine on the outer main I should be able to run that engine onto the second mainline with the same hand held and to take it one step further can I run that engine to and onto the other mains without problems..............Paul
Paul,
If I have a DCS engine on the outer main I should be able to run that engine onto the second mainline with the same hand held and to take it one step further can I run that engine to and onto the other mains without problems.
That's correct.
Access to this requires an OGR Forum Supporting Membership
