Skip to main content

The second tier on my layout is controled by the DCS remote control unit. When I change direction the front and rear headlamps will not light up. If I place the locomotive on my main line track powered by a CW 80 when I change direction the lamps light up and work in that direction.

Any ideas or suggestions? 

Original Post

Replies sorted oldest to newest

You know, I run TMCC and Friends, with Lionel bricks, so Conventional operation is not really done on my layout, but how many of these threads concerning odd locomotive behavior contain a phrase like: "...track powered by a CW80..."?

It seems like a lot. I read this thread for the MTH 44T angle - and there was "CW80" again. Huh.

D500 posted:

You know, I run TMCC and Friends, with Lionel bricks, so Conventional operation is not really done on my layout, but how many of these threads concerning odd locomotive behavior contain a phrase like: "...track powered by a CW80..."?

It seems like a lot. I read this thread for the MTH 44T angle - and there was "CW80" again. Huh.

A little unfair don't you think considering the original poster stated the 44 tonner worked as it should when he ran it on his main level using the CW80.

Have  I missed something?

Happy railroading,

Don

The DCS-RC will reset new PS/3 locomotives to factory defaults.  The 44-Ton locomotive is new enough to have the latest features, try that for a first step.  See if it behaves after a factory reset.

Turn off power if on
Wait 15 seconds
Turn on power:  the engine should be dark and quiet
Press no other buttons
Press SND
Press DIR
Press "-"  (on the gray rocker in the center of the remote.  Also is the speed down button.)
The engine will give a two honk response and will be sitting on the track running
The engine has now been factory reset, and is ready to run with your DCS Remote Commander system.

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×