Skip to main content

I had some dirty track and while running in DCS I took the MTH Premier loco off the track and then put it back on at another spot. It went into full speed mode (like it does sometimes when I do that) so I pulled it off and e-stopped DCS. When I went to repower the track the loco would not work now at all. It shows up on the DCS and the track has power but the loco is dead. It was working just fine prior to all this.

 

Anyone else have this happen and how did you get the loco back?

 

Thanks!

Original Post

I believe I had this problem with my SD50(PS3), I think I turned of the power at the wall placed the loco back on track,turned the power back on, and re-astablished the watch dog signal, you'd won't to make sure you where on a clean section of track, but the DCS form is the best place to get help with this. Id also make sure the E stop is disengaged.         Stephen    (cTr...Choose the Right)

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×