Skip to main content

Production Number: 30-2521-1

PCC Electric Street Car wProto-Soundr 2.0 - Chicago # 4015

I bought this used and was informed that it is in working condition. Before I even put it on the track I opened it up and replaced the MTH battery with a standard 9v battery. After applying power I get no lights, no sound, and just a slight hum.

  • I tested this on my test track via a transformer and on my main layout with the same result.
  • Used 2 different working 9V batteries.
  • Checked for any crimped wires or loose connections - all seemed fine

 

Anything else I can check here or is this a lost cause? I would rather just send it back for a refund if there isn't a cheap solution.

Thank you in advance!

Original Post

Replies sorted oldest to newest

that engine has the ps 2 5 volt boards and they either fail dead or shorted in either case the boards can't be repaired!  i could put a relay in it if you don't care about sounds. ps 3/2 board can be installed and made to work again but would be $150.00 to 200.00 depending how much work the tech would be required to make yours trolley car work again!

hw much do you want to spend on repairs!

Alan

Add Reply

Post
This forum is sponsored by MTH Electric Trains
×
×
×
×
Link copied to your clipboard.
×
×