Skip to main content

This 1 probably already covered but here's what's happening;

Started noticing a particular MTH unit only showing up on the wifi devices as an address. Still able to operate it, except that the app not knowing what unit it is, gives me no aux control screen is blank. The unit does show up fully in the remote, telling me the TIU knows the unit info? I've rebooted everything & all equipment has current firmware. Now, another mth unit is displaying the same.

  My next move is to delete both units from all wifi devices and let the get reinstalled?

1st gen TIU (9 pin serial)

pig tailed to cab 1 & wifi module

Both are ps2

Thanks

Original Post

Replies sorted oldest to newest

Yes, The data was imported from remote. Once I deleted the 2 locos and allowed the app to reinstall them, not only did they come back fully on that device, but they both instantly showed up on the other 2 devices being used.

  Thanks & by the way; Pinch me because I must be dreaming. I grew up sticking my finger in a hole to dial a phone after getting access from the other people on the party line & now I'm controlling my trains & layout in ways I never imagined with a telephone in the palm of my HAND!  

Add Reply

Post
The DCS Forum is sponsored by
×
×
×
×
Link copied to your clipboard.
×
×