Searched the forums but haven't quite found the answers, so posing questions to people who already have set(s) of MTH either single or dual head traffic lights.
Can the pole be carefully re-bent in opposite direction or will tubing break (metal or plastic tubing)? On my layout one signal would have to end up in middle of a track so head could shine into correct lane. Therefore, my solution would be to make pole bend over other way, but then the lights will be upside down (green on top, red bottom) and have to re-position LEDs unless I want to have an Irish traffic light ( http://gizmodo.com/the-story-b...fic-light-1545301615 ) !
If it can be bent other way, can heads be "easily" opened to allow LEDs to be re-positioned? How are LEDs wired for dual heads, that is outer (left side as normally viewed) head wires go into center head to connect there and then center head wires run down the pole and out the base? Or are both heads independently wired and both sets run down pole and spliced at base?
F.W.I.W, Bill Hudson had asked similar questions in 2012 but apparently received no replies and topic replies is closed.
