Skip to main content

I'am running a power master base and PM1...with a brick...in command it works fine,in conventional the voltage comes up in 3-4 volt increments  I have 2 cab 1s both react the same,I have changed the PM base and the PM 1...same thing...the brick is putting out 18v...anybody got any ideas?is it possible both cab 1s are bad...  I also tried a ZW...same results..HELP!!thanks  joe

Original Post

Replies sorted oldest to newest

Joe:

This is from another thread. Maybe it will help

"Be aware that when using a Cab-1, Legacy locomotives will be set to 32 speed steps "out of the box."  You can change this by addressing the locomotive and using the hidden buttons under the cover at the bottom of the Cab-1.  Pressing "L" sets the locomotive to 32 speed steps and no momentum, pressing "M" gives it 100 speed steps and no momentum and pressing "H" gives it 100 speed steps with momentum.  Once set, the speed steps/momentum will remain in effect until changed.  I set my Legacy locomotives to "M" for what that is worth. "

Joe

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×