I'am running a power master base and PM1...with a brick...in command it works fine,in conventional the voltage comes up in 3-4 volt increments I have 2 cab 1s both react the same,I have changed the PM base and the PM 1...same thing...the brick is putting out 18v...anybody got any ideas?is it possible both cab 1s are bad... I also tried a ZW...same results..HELP!!thanks joe
Replies sorted oldest to newest
I am not sure but, the Powermaster may be programed for either 32 or 100 speed steps. At my age my memory is failing, check the Powermaster manual .
Ray
Joe:
This is from another thread. Maybe it will help
"Be aware that when using a Cab-1, Legacy locomotives will be set to 32 speed steps "out of the box." You can change this by addressing the locomotive and using the hidden buttons under the cover at the bottom of the Cab-1. Pressing "L" sets the locomotive to 32 speed steps and no momentum, pressing "M" gives it 100 speed steps and no momentum and pressing "H" gives it 100 speed steps with momentum. Once set, the speed steps/momentum will remain in effect until changed. I set my Legacy locomotives to "M" for what that is worth. "
Joe
Access to this requires an OGR Forum Supporting Membership
