Skip to main content

Replies sorted oldest to newest

Use a dpdt relay,switch the coil with the AIU. Use one contact set to switch the turnout,use the other to work the dwarf signal. Not familiar with the AIU,I assume it has memory when power is removed.. If not use a twin coil latch relay with 2 sets of contacts. A 24VAC relay will work on 18 volts. If you use a 12 VAC volt supply you could use a DC relay with a bridge.

 

Dale H

The DZ 1000 switch machine is designed to piggy back with the DZ 1008 relay module.

The relay module should provide one set of normally open, common, normally closed contacts for switching your dwarf lights.

 DZ1008 installation instructions.  Click on the underlined phrases to link.

Both the DZ 1000 switch machine and the DZ 1002 push button also have direction  indicator lights.

Contact Dennis Zander, Z-stuff. 

Last edited by Mike CT
Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×