Skip to main content

Replies sorted oldest to newest

Uh-oh, I got 2-56's for mine too.

 

Went back and looked at the emails they sent about all that and no where did they say 2-56 screws?  Think I did get a Kadee bit and tap for 2-56. Wonder why I got that? Don't know if I found it on their website, in the directions or dreamed it. Getting old, mind is going... will look around a bit more tomorrow.

Last edited by rtr12

Ok, I was thinking scale coupler on steam cowcatcher.  Your talking about adding kadees.

 

MTH uses 2 and 2.5mm on the PCB mounts.  My local hardware store has screws that size, you could go to a Taylor or something similar and test fit.   Or if the engine has a switch pull one screw and see if that fits.  It is a 2mm screw.  G

Originally Posted by GGG:

Ok, I was thinking scale coupler on steam cowcatcher.  Your talking about adding kadees.

 

MTH uses 2 and 2.5mm on the PCB mounts.  My local hardware store has screws that size, you could go to a Taylor or something similar and test fit.   Or if the engine has a switch pull one screw and see if that fits.  It is a 2mm screw.  G

Will see if I can find some screws in those 2 & 2.5mm sizes. Good to know this before starting to convert anything. Thanks GGG.

 

Kadee has a chart on their website for their couplers, the O-gauge part says 2-56 screws are the most commonly used. So much for that, but at least I know where I got the 2-56 screw sizes anyway. Kadee doesn't seem to offer any metric screws on their website. They do have a lot of other good info on their couplers though.

Post
The DCS Forum is sponsored by
×
×
×
×
Link copied to your clipboard.
×
×