Skip to main content

I have gotten hold of an F3 diesel (Premier) , Proto (QSI), and like the shell but want DCS. I also have a Proto 2.0 F3 (RailKing) model. I was hoping the chassis if each would be somewhat interchangeable but see there are considerable  differences.  

The questions:

Has anyone ever changed out the electronics from a PS 2 into and older Proto (QSI) chassis?

How difficult would it be?

And might the PS 2 motors fit the old Proto trucks (gearwise)?

Lots of questions but the experience of members on this forum is invaluable. Thanks for reading.

Original Post

Replies sorted oldest to newest

I have gotten hold of an F3 diesel (Premier) , Proto (QSI), and like the shell but want DCS.

 

Question . Do you also have the F-3  chassis &  motors???? . If so You could do a transplant of the railking  circuit board.  In my humble  opinion it's  doable.  The proto-2 upgrade manual on MTH site will be a big help. It has a schematic of where all the  wires plug into the board.   Fun project.

Last edited by Gregg
GGG posted:

Buy a PS-3 Diesel kit and convert it.  Easiest method.  Other wise you will be missing out on features since the RK F-3 harness does not support all the light functions on a premier engine.  Yes, motors are different size too.  Kit has everything you need.  G

I'm doing just that.  Found a cheap NYC F3 ABA set, gutted the PS1 electronics out and sold them.  Purchased two PS3 kits which GGG added sounds for me.  Instead of just one ABA unit I'll have a A unit and a AB unit which I'll run in a ABA lashup.  I'm also detailing it by gutting the lobster claws and installing scale pilot and kadee couplers.

Add Reply

Post
The DCS Forum is sponsored by
×
×
×
×
Link copied to your clipboard.
×
×