My loco was lost in the remote menu? When I try to add “engine found” add3d to location 100. When I try to proceed, “no engine found”????
Original Post
Replies sorted oldest to newest
Like Lionel, the MTH DCS system will only accept locomotive addresses of 1-99, there is no 100.
I would say reset the remote n tiu n then try again! you might download the remote engine into your laptop computer so you wont have to reload all your engines!
Alan
Well there is a 100. It must be some sort of error code? Anyhow, all the other engines load up. I believe it’s a problem with engine. I seem to have nothing but problems with the mth - very frustrating.
So go to engine and delete engine 100 out of remote. How many engines are in your remote? Make sure your engine is the only one on the track, DCC/DCS switch if it has one is in DCS. Try to readd engine. See what it does. G
