WHAT WENT WRONG: To avoid a rear end collision I picked up the locomotive before it struck the rear of another train. After placing the locomotive back on the track it would not operate in DCS or conventional. At the time of failure I was operating DCS.
THE ENGINE: RailKing CSX 9993 F40 Diesel PS2
WHAT I'VE TRIED:
1. Battery check is 8.85 volts
2. Set up separate programming track.
3. Tried engine recovery-No engine to recover.
4. Deleted Engine then tried Add Engine - No engine to add.
5. No confirming click when track is powered up.
6. No lights, bells, or whistle.
What should I try next ?
