Skip to main content

Okay, I know the plug has to be in the outlet. I have 14v and 10v accessory connections on the MTH Z4K. The 14 v is being used by the Lionel TMCC Legacy base for the command fastrack switches. I don't know if the 10v is enough to light building accessories. So I will use my MTH Z1000 (14v accessory output) which is not being used for anything else. But I need to know how to connect all the buildings to the power source. I have Railking buildings (country house, 2 row houses, 1 country freight house, and switch tower),  Lionel structures are #132 station, #256 freight station, four #2256 station platforms, and a #395 floodlight tower and soon to be delivered a Riverleaf Models building. Probably will be making a few building purchases in the future. My Woodland Scenics are on the Just Plug system. My questions are:

  • Can the different manufacturers buildings be used in one set up?
  • What gauge wire is used for the MTH buildings, Lionel structures and Riverleaf Model structures?
  • Should I use terminal blocks (I have 2 unused 12 port MTH ones) at the locations where the buildings are clustered, then connect the strips to a buss wiring system which connects to the Z1000 14v output?
  • What's the wattage limit on the light bulbs for this set up?
  • What are good electrical connectors for this? I need to extend the MTH building wires to the terminal blocks, or if it's suggested, directly to the buss wiring.

Your advice is appreciated. Thank you, Fred in New Hope.

     

Last edited by luvtrains
Original Post

Replies sorted oldest to newest

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×