R2LC Question, Railsounds 4.0 question

Here you go.

John, that one and all the other boards needed to be memorized prior to the Lionel school.  Having been an MTH repair guy, I spent many hours memorizing the pinouts.  It has paid off greatly as any Lionel engine can be repaired without going to charts. 

I remember most of the common pins, but I have to look at times for some of them.  If I really needed to remember them, I'm sure I could.

Perfect John,

I'm all set and thanks

Gary,

 where have you been??

I don't do much with trains in the summer time, so not much posting until I get busy with the layout.  Mostly post or read the real train section of the forum but that is a changing as I have John's new puffing board in hand to go in one engine and Electric RR new railsounds board to go in another.

So I guess you can say I'm back.

Ok, who has the pin out for the two RS 4.0 boards?

You want a lot, don't you?

Here's the whole load.

Again John,

You are the man.

Well, that was an easy one, we need a "stumper" now.

Well I'm all set, you saved me a ton of time tracing out these lines myself.

Well, I certainly wouldn't want to do that!  One of my issues with working a lot of the Legacy stuff, no diagrams available for the connections.

Hopefully Phil H will start offering Service Schools again focusing on the newer Legacy and Vision products. 

Pete

I'm not holding my breath, but it would be very nice if that happened.