Hey all.
First time I'm doing a reverse loop. I've attached a scarm screenshot of the layout and the loop in question. For the anti-derailing feature to activate, you need to insulate the inside rails of the incoming points to the switch (not the base if you're holding it upright).
The red circles represent where the insulated rail pins are located. Disregard the purple stars. These are Lionel O-31 switches.
Did I set this up correctly? All seem to work fine and switch over when you approach the switch, except the right-most switch. It only activates from the curved approach and not the straight approach.
Still a newbie here. Layout is almost done. Will post some pics one done. My first "adult" layout.
Thanks!!
