Would anybody happen to have a set of the Micro Mark O-gauge rollers #83417?
If so, would you be willing to post 3 or 4 clear pictures of one of the sets? A picture of the bottom is most important. There is a picture on their website but I could use a couple more so I can fabricate a couple of sets. What is the OD of the ball bearing rollers? I'm guessing 3/8" diameter.
Thank you in advance.
Richard
LIONEL6457
Replies sorted oldest to newest
The bearings are 1/2" OD.
If you are a three rail person, you would be better off to get rid of the fiber connector and use a continuous piece of aluminum. The fiber connector adds a lot of effort to making the roller stand and isolating the rollers increases outside rail conductivity issues to the wheels.
@David Johnston posted:If you are a three rail person, you would be better off to get rid of the fiber connector and use a continuous piece of aluminum. The fiber connector adds a lot of effort to making the roller stand and isolating the rollers increases outside rail conductivity issues to the wheels.
And what are you using to connect power to the rollers?
A brass strip on plastic screws.
John and David- Thank you very much for your replies. Your information will be helpful.
Regards,
Rich
Access to this requires an OGR Forum Supporting Membership
