Skip to main content

Closed1 reply

smoke unit

J jojofryOGR Forum Member

I have a mth dash 9 with ps2 3v the smoke unit runs but doesnt smoke .. With the shell off i tested the board with a volt meter where the resisters are and it says .7 volts i assume this isnt normal any idea what it is? .. I have tested it right out of the plug on the board and its the same....The motor runs the elements are not getting hot ..

Original Post
G GGGOGR Forum Member

It is pulsed power so the reading may be correct.  One I recently read was only 1.9V.  What does the resistance measure between the elements?  Should be 8 ohms.  If the fan is running correctly and blowing out the stack, I would inspect the wick to see if it is hard/burned.  Most times you just need to repacking the wick, if the fan works fine to restore smoke.  G

Views: 418
Post
The DCS Forum is sponsored by

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×

Access to this requires an OGR Forum Supporting Membership

OGR Forum Supporting Membership

Help support this forum with an OGR Forum Supporting Membership.
You will be able to watch the videos in the INSTRUCTIONAL VIDEO FORUM!
A one-year OGR Forum Supporting Membership is only $12 per year, so sign up now!


    OR     


Access the ALL the OGR VIDEO FORUMS AND  over 300 back issues of OGR
with a DIGITAL SUBSCRIPTION!



$12.00 per 12 Months (plus tax if applicable)
×