Skip to main content

I have the Lionel 6-24295 Cowen's Corner Hobby shop hooked up to the accessory terminals of a small Tyco transformer with an on/off switch powering the transformer on and off. The building has been hooked up and working fine for several years now and has been run minimally. Today I noticed that the building lights were all functional but that the three operating train layouts in the building were not. I checked the wiring and transformer. The transformer had only been powered on for a maybe ten or so minutes but was extremely hot to the touch (small Tyco transformer I used just for this accessory nothing else is connected to it). I swapped out transformers checking all wiring and connection. But I am still seeing the same behavior.
Has anyone had this problem before? Any ideas where to start troubleshooting?

Original Post
Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×