Track Joiner Clips for GarGraves or Ross track?

http://www.gargraves.com/accessories.html

Don,

I checked that out prior to posting.  I'm looking for rail joiner clips - the kind that slide on / off between separate pieces of track.  I know Atlas uses them and they are common in HO, but I need an O gauge version that will work (and conduct electricity) for GarGraves track.

George

I’m not aware of anyone making rail joiners for Gargraves so the question is will any of the several different types of rail joiners listed on the Atlas O website work on Gargraves Track?

If you can’t find something that will work, I can send you some of the Gargraves #910-4 Track Connector Strips.  Just reimburse me for the postage.

Bill

Been using Atlas track for 40 years and your not going to find anything like that for gargraves. My suggestion is to connect the track via a plug on both sides and just align the track as needed . If you do it this way you won't need any rail joiners.

David

All,

I appreciate the advice.

Bill - I very much appreciate your offer, but I have some of those.

I ended up solving my problem this way.  The original problem was caused by the end of a switch not lining up with the boundary of a removable piece of subroadbed (sitting on an access hatch).  I solved the problem by adding a short piece of straight track to make the track and subroadbed end at the same point.  I will use GarGraves "fit-up" connectors to bridge the gap.  The problem was complicated because I had a number of other alignments that had to be perfect to make this work.  I think I nailed it.

I will eventually publish photos of the finished area in the Photo Album as a comment to my PRR Panhandle Division.

Thanks again.

George