Trying to get layout going and set up loop with 2 ross switches for inside passing siding. I finally got Ross switch wired and hooked up power and ran engine several times around but on 1 place was kind of stopping or minor derail. I thought fixed when lowered the switch a little. Using menards track and had 1/4 spacer but was little high, so thought fixed and went through fine but still hesitating. I thought pin not tight enough so ( Here is the error I did) taking out track piece heard a little pop, I forgot to turn power off to track. Now when I apply power to engine (conventional) the breaker on the 180 brick trips. Using the zwc controller that has ports for 4 180 bricks but only have 1 plugged in. When hit reset button on brick the green light on zwc comes on but when apply power the brick trips and red light on zwc does not come on. Any thoughts?
help please.
