Running engines with both being assigned the same engine ID Set as Cab1 with Railsounds 5
- Assigned A unit as #12. Assigned B unit as #13.
- Both will run fine as solo and also coupled.
- Sounds crew talk come from both engines.
Running both engines as a lash up with #12 (A) being assigned as lead
- I create a train (in this case #8).
- I start buy adding the A unit. No problem
- I then at the B unit. There is no icon for crew talk or sounds
- If I press set, it says that it is programming trains, then ready to run
- If I do that, the train will not power up.
Running both engines as a lash up with #13 (B) unit as lead
- I create a train (in this case #8).
- I start by adding the B unit. No problem
- I then add the A unit. There is no icon for crew talk or sounds
- If I press set, it says programming trains, ready to run
- In this case the newly created train runs with sounds coming out of the B unit
- There is no control of the headlight. It stays in the off position
I have never had experience with 3rd Rail sunset. I think the instructions were pretty straight forward. Do you have some thoughts on where I am derailed?