Using 1034 transformer for fixed power only

Took a while to realize you are talking about Ross Custom Switches...RCS usually identifies a Lionel uncoupling track...

Posts B-C will provide 14 volts to your switches. Wire them according to this diagram from Ross' website.

Larry

jitney55,

Just in case.......Make sure your 1034 is in phase with your ZW. Just a thought.

rockstars1989,

Nick, I understand what TrainLarry is asking, not a problem . What I cannot understand is your statement .

Larry thanks for the info - I should have said Ross Custom switch instead of RCS -

sorry for the confusion.

You can probably figure out the answer to your own question, and have the satisfaction of doing so.

Start with "How many volts do I need?"

Then find the set of binding posts that supply close to that voltage. If there is no combination that gives you the exact amount you need, use one of the variable sets and adjust the voltage to your requirements.

Question:  Do you have a digital volt-ohm meter?

Thank you, Arthur - I think the B+C combination is what I need for 14V. Had only used the 1034 for variable to run a small 0-27 set long ago and was not familiar enough with the #'s on the posts, etc. - thanks again!

Thanks Pappy!