Vision Line Challenger - Dynamo

With smoke set to high all you need to do is toggle on/off for effect.
Effect also works with shut down sequence


Why don’t you reset the Engine, and all its features back to factory and see if that works?


Great results with my Vision/ Legacy Engines Smoke Output with this simple tool.


I find that after I add smoke fluid to any of the Engines I own I have better luck if I blow lightly thru this piece of new small engine gas line/ The size is perfect to go completely inside special effects fluid holes as well as stacks.
Best part is you can use it on engines that are an arms length away.  You do not need much air pressure, just a light puff should do it.
I hope you find this helpful.






Hope this helps…

K.C.

Make sure it is physically turned on with the switch.  I believe it's under one of the sand domes.

Mine just stays on when i turn my smoke on. It comes out the dynamo and right bottom..

Thanks guys. I have everything set as mentioned including blowing in it, but no smoke out of dynamo or right bottom. Guess I will have to get it to service.K.C, what size tubing do you use & which is Aux Prog button? Great idea.

       
       

Hello John,
I was hoping it was something simple, and you would be able to fix your smoke issue.
I think if you over fill the special effects smoke unit that will make it quit working??

The gas line I’m using is for a Craftsman Weed eater, and was bought by comparison.
I remember it being the smallest inside diameter gas line the store stocked…I hope that helps.

As for the Aux/ Prog,-  they are two separate buttons…I think???

K.C.