Hello all,
I recently installed DCS WiFi on my layout. After it was up and running, I noticed a significant decrease in track signal over the whole layout. Readings that were in the 8 - 10 range are now in the 5 -8 range or lower. The "read" feature does not find all engines (perhaps 5 of 13) and in some parts of the layout, the engines don't respond at all. Has anyone else encountered this? What should I be looking at?
Thanks,
Mike Hartings
Replies sorted oldest to newest
Does your signal go back to 10 if you unplug the wifi?
Mike,
Are you getting the lower DCS signal reading with the DCS App or by using the remote? If it's the remote, I would almost bet that the issue isn't caused by the WIU being attached. It's more likely that when you attached the WIU, you inadvertently did something else that's now affecting the DCS signal.
Access to this requires an OGR Forum Supporting Membership
