I am very unfamiliar with these and want to know if Williams makes sets of these and if you guys had any of them would you mind sharing pictures? Thanks in advance!
Original Post
Replies sorted oldest to newest
It's the same roadtrack and vehicles that were called K-Line, and then K-Line by Lionel Superstreets. Search for "Superstreets" and you ought to get lots of hits. There is one thread I posted this afternoon with one picture of some . . .
No E-Z Streets sets available yet...just the individual track components.
A few weeks ago I order from Ready to Roll some E-Z streets made by Bachamann and mate them with K-Line Superstreets and they work perfect, no problems at all; the E-Z are a little darker than the K-Line
Thanks for the responses guys! Another question if you dont mind...(a few actually) What do rhe power wires hook up to the track with? I cant seem to find a "terminal section". Also, what kind of power supply do you suggest? I have read that they are DC powered. Thanks!
Any section is a terminal section. WBB sell a wire set with small 'plugs' attached. These plug into tabs on the bottom of all sections. They work great BTW.....
With K-Line's version of Super Streets only the 10 inch section had both power hook-up tabs, the curves may have only one power tab and it was for the outside rails.
The small sections; 2 & half inch don't have any power hook-up. The five inch might be the same as the curves for power hook-up.
To secure the track to plywood table I used a # 4 phillips head screw, counter sunk style, that are 3/4 of an inch long.
Lee F.
Originally Posted by lionel2024:
Also, what kind of power supply do you suggest? I have read that they are DC powered. Thanks!
The standard SS and EXs vehicles will run on AC or DC - and go forward only in all cases (They each have a full wave rectifier inside). so you can run them off any standard O gauage AC power supply or just about any N or HO gauge Dc set. I use a Tech III DC power supply.
If you take them apart and remove the recitifier snd resolder the leads, they will then only run only on DC, but they will reverse when you reverse polarity. I've done this to all but the only three of my SS vehicles (two that are rare K-line vans from the first series of production and one (the only one I have ever seen) that has an e-unit in it (and it to runs on AC or DC and the e-unit will F-N-R on either!)
