Skip to main content

Strange issue, if I leave the command base off I can run the ZW in conventional mode with levers. When I plug in the command base first then turn on the ZW, track 1 works in conventional mode using the CAB1 and Track 4 automatically starts in TMCC mode applying 18v to the track. I have try codes to put track 4 back into conventional mode with no luck. Any ideas?

Original Post

Replies sorted oldest to newest

If a command signal is present when you turn on the ZW, track 1 (A) and 4 (D) should stay at zero volts even with the handles turned on full.  While track 2 (B) and 3 (C) will immediately come up to what ever voltage their handles are set at.  1 and 4 are normally for track and 2 and 3 are for accessories, so this logic makes sense.

 

So track one is actually working in TMCC mode.  The CAB-1 can control the voltage as long as the handle is turned on.  There is some problem with Track 4, unless you have the terminals confused.  Try a rest.  G

Post
×
×
×
×
Link copied to your clipboard.
×
×