Skip to main content

Replies sorted oldest to newest

A few things I can think of:

*Be sure you are using the correct traditional tungsten filament #51 lamp. Any other lamp has different electrical properties that are not matched for the thermostatic switch.

*Adjust the adjustment screw so that it just ever so lightly makes contact. (If it is too tight, it won't ever break the circuit causing it to always heat)

*Test for continuity thorough the thermostatic switch - if there is none, replace.

*Re assemble the 193 and test the thermostatic switch under normal operation.

 

Service Documents are here and mention an adjusting screw:

Attachments

Images (1)
  • mceclip0

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×