Skip to main content

I obtained a replacement tender for a Lionel 1501 Northern (same three prong connector) that the foam between the floor of the tender and the sound board was dried out. I found a suitable replacement that I cut to size, but don't know what adhesive (glue) to use and not mess up the connections on the sound board. I used an old toothbrush to carefully remove the excess  dried IMG_8359IMG_8360foam from the back of the board and don't believe I caused any harm to the the connections. Any advice gratefully received. BW

Attachments

Images (2)
  • IMG_8359
  • IMG_8360
Original Post

Replies sorted oldest to newest

Vandalia Guy posted:

I obtained a replacement tender for a Lionel 1501 Northern (same three prong connector) that the foam between the floor of the tender and the sound board was dried out. I found a suitable replacement that I cut to size, but don't know what adhesive (glue) to use and not mess up the connections on the sound board. I used an old toothbrush to carefully remove the excess  dried IMG_8359IMG_8360foam from the back of the board and don't believe I caused any harm to the the connections. Any advice gratefully received. BW

I'd use double sided Scotch sticky tape

Thanks, I just happened to have purchased a roll last week. However, the tape wasn't strong enough to hold to the back of the board, so I also had just received some Tacky Wax. THAT applied in a sliver in about six places is strong enough to pick the unit up by the board edges along with the tape holding the foam to the floor. When I get the shell repainted in ACL colors, I'll post the whole engine/tender combo. 

Last edited by Vandalia Guy

I've been using the foam strips that ERR used to ship for years, it's "Double-Stick", about 1/8" thick.  That has never failed in any of my applications.  The biggest issue is getting if off if you want to remove it!

One thing to do with foam, trim any long leads that project from the bottom of the board, that allows the board to get a better contact and hold.

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×