DZ1000 and Controllers

solder on extension wires?

or use phone cable to solder extensions?

was this a trick question?

SD60M: Use terminal blocks. Very flexible.

@AlanRail posted:

was this a trick question?

@SD60M,

Alan has obviously assumed that you should've known the answer to your question before you asked it, and therefore you shouldn't have asked it.

Are you handy with a soldering iron?  Then follow his recommendations.

If not there are several clever non-solder methods for connecting things.  Leo's suggestion above is a good one.

Here's another example, follow the link:

    B wire connectors | Arthur P Bloom

Mike

Done with small twist connectors.   DZ 1000, and DZ 1008 leads under the table, connected to the DZ 1002 remote switch.  DZ 1008 relays are the two black boxes pictured.

I have used phone cables to provide a straight run with no intermediate connections needed.  These cables are color coded and as folks move away from land lines are readily available at thrift stores for next to nothing.