Hi Everyone,
I have a question about Pre Bachmann EP5 that I would like to wire in Series. It has flywheel motors but has the True Blast 1 horn and all wireing is soldered to the reverse unit. I was wondering if there is a diagram for wireing those in series.
Thank you all in advance for any help.
Gene
Replies sorted oldest to newest
Wiring motors in series:
The motors have two wires attached to them. They could be any two colors, but for purposes of this discussion, we will assume that each motor has one white wire and one yellow wire, OK?
-take off the shell
-Follow the white wire from one motor back to the board and snip that wire at the board.
-follow the yellow wire from the other motor back to the board and snip it off at the board.
-now you have one motor with a long unattached white wire, one motor with a long unattached yellow wire and two wire stubs on the board.
-take the long unattached white wire from one motor and connect it to the long yellow wire from the other motor. You can connect them with wire nuts, or solder and heat shrink.
-put some tape or heat shrink on the stubs of wire on the boards if they can touch anything.
-test drive the loco before putting the shell back on.
That's all there is to it. Your loco will run more slowly and be less inclined to slow down in spots where the track voltage is low.
There are other ways to do it, some that are more easily reversible, but this is the quickest/easiest way.
Just to help prevent any confusion, I am fairly certain the motor wires on Williams locos are blue and yellow.
Thank you for your help, I will be converting them tomorrow.
Gene
Access to this requires an OGR Forum Supporting Membership
