Skip to main content

I’m using the Legacy 990 system. I think I’ve got it properly installed in a Lionel TMCC Pennsy T1. The procedure to program the R2LC and Feature Code refers to setting the Program Switch to Pgm. I presume they are referring to the small switch on the CCM, not the switch under the engine? Is the board’s switch used to program future ID assignments essentially replacing the engine’s Run/Pgm switch?

Thanks...Rich

Original Post

Replies sorted oldest to newest

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×