Got my Chessie, ummm

What transformer are you trying to use with it?  Unless it's on the compatible transformer list in the back of the manual, chances are the locomotive will go into a protect mode and will not run.  These trains are full of delicate electronics and the wrong kind of transformer power output can fry the boards.  So I'd either wait or find someone that has an approved transformer to run the locomotive.

Pennywise.

Congratulations on your new engine. Is it Lionel or MTH or ?

Also, what is the model number (i.e. 20-30078)Knowing this information will enable us to help you better.

Paul

Can you specify what type of engine it is?  You say it's a Chessie, but there were a lot of those made over the years so it would help if you specified who made it, what the catalog # is, etc.  Also as sinclair alluded to above, the type of transformer you're currently trying to use would also be helpful in helping you troubleshoot.

If this is a newer PS3 equipped MTH engine it will take several moments before it will do anything as the capacitor inside of it charges up first, so give it about 15 seconds or more.

If there's still no change, did you already try to cycle the power on the transformer to see if it will move?  Some engines like MTH start in neutral first when power is first applied so you have to briefly shut the power off (either by using the transformer handle or pressing and briefly holding the direction button) and back on to cycle the direction unit.

At class but it is mth proto 3 sound, I wax suggested the Z1000 and wireless dcs command.  I have not had anytime e to mess with it but trucks are locked. ATM all I know is the transformer is a standers Lionel strarter

lionel cw-80 transformers are known to not work properly with MTH engines.  I t may be your transformer

oh i just want to run it so d@mn bad. i dont see a recommended transformer size on back,it came with a white manual and a big colorful DCS guide

I'd NEVER run a MTH PS3 loco with a Lionel CW-80 transformer.

Once you have a MTH type transformaer here is a few things to check before running.

MY PS3 locos have switches under water hatch for 2-3 rail. I had to flip mine back and forth into the correct position before running.

ALSO....the drawbar....metal bar between the loco and tender/coal car...is a little tricky to get seated 100%....which it has to be or not run.

If you bought locally I'd have the dealer check it before going further.....or osmeone with a few years under their belt.

Good luck!

I have no train person near me, my hobby towns are stupid beyond years. They even admitted they were. But I will wait till I am all set to run 

"I have not had anytime e to mess with it but trucks are locked."

This is normal.  The wheels on the trucks will not turn by hand.  They will turn when the motor turns them.

Where are you located in N.C.? We have members in and near NC maybe they can offer you a hand.

Scott Smith

Near conover nc, hour from Charlotte 

There use to be a MTH dealer in Hickory it doesn't appear they are still in business. You are about 50 miles from the Little Choo Choo Shop in Spencer. When will you get your Z1000? More than likely I will have to drive to Greenville, SC this month. I could loan you one if it is going to be a while before you get one.

Scott Smith

In a PayPal claim were I got scammed, if goes well 3 days. I have a few things I've talked to members about buying too. I appreciate it, but I can wait if it is indeed 3 days