Skip to main content

Gentlemen,

I have performed a Proto-ectomy on an MTH Cleveland Union Terminal Geep.  All has went well and the train is performing all functions.  Now it's on to the lighting.  It has been suggested that I need to take care here.  That the front and rear light hookups on the ERR board cannot just be hooked up to the existing LEDs inside the body.  In addition, although it was suggested that I would need a resistor here, the person could not offer advice on what resistor to use.  

Any help here would be appreciated.

Troy

Original Post

Replies sorted oldest to newest

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×