Just on one of my engines,the line goes across when I dial up but the "fill in bar" as I call it, lags very,very slow behind.No matter what I choose when I push speed control,it doesn't change it.How do I get it to go back to normal like all my other engines?Book doesn't explain it.Thanks,Nick
Replies sorted oldest to newest
try this;
Grey-Bar
The Grey-Bar is your engine’s
“Commanded Speed.”
The Grey-Bar always seeks the target line.
The Grey-Bar moves across the speed graph at
a pre-set rate.
The Momentum setting L, M, and H, is
how you decide a pre-set rate of acceleration or
deceleration for your train and the speed graph Grey-Bar on the display. Momentum setting is default
pre-set to “M,” Medium.
For more info, see the Momentum section on page 27.
Hi Nick, I agree with BigDodgeTrain in that it sounds as though you may have inadvertently set a higher momentum setting than you desire. Try setting the momentum back to 'M'. With the Legacy CAB-2 you can fine-tune the setting to suit.
Thank you I will certanly try that.N.
The med setting also can vary from 1 to 8 and the higher the number the slower it will accelerate. I use number 6 on my engines as the acceleration is as I like it. You turn the red dial to change numbers. Go to low momentum for the fastest acceleration.
Access to this requires an OGR Forum Supporting Membership
