Skip to main content

Replies sorted oldest to newest

Like the previous post, the exact model of the accessory and any controller you're using to connect it to the Legacy system.

 

There has been issues with the Legacy base driving too many serial devices, it doesn't have the drive that the older TMCC command base has.  If you have a number of serial devices hanging off the Legacy base, that may be the issue.

 

Note that we're just guessing here since we have no details.

Sorry fella guess that would help,  I already know the base will not drive many serial devices, so I hooked an asc controller only to the base to get it to work.  It will flash the light on the base when you hit boost but it will not flash the little green light on the controller.  If I hook this back over to a cab-1 base it will work just fine.  The cab-2 and base will run engines just fine, but nothing thru the serial port.  chief

Originally Posted by BobDuckworth:

I understood the Legacy system needed a SC2 to run accessories and switches.


I do use SC2's controlled by the Cab 2 to operate my switches and accessories.  In this way you use the Switch and Accessory buttons on the Cab 2.

 

I have three accessories controlled directly from the Cab 2: Backshop, TMCC Culvert Loader and Culvert Unloader.   These are addressed as Engines.

Post
×
×
×
×
Link copied to your clipboard.
×
×