Lionel TMC ENGINES LAGGING, HESITATING

If it's multiple locomotives having the problem, start looking at the layout.  First step is to check the power supply and make SURE that the Legacy command base is plugged into a properly grounded outlet.  Next, hold a hand on the top the powered engine and see if that solves it's startup issue, that would indicate a TMCC signal issue.

Thank you for your reply John as I appreciate it. I will do with you said. Much thanks, best and Merry Christmas Jerry

Hi John, I did as you suggested but the engine, Lionel 2356 celebration series is still lagging on Legacy. I tried on cab 1L and it runs okay. It is not running well at all on Legacy control? What do you suggest doing? Should I reprogram the engine? It has two pull more Motors. Do I need updates on my legacy command base? If so can you advise how to do that please. As usual, thank you for your help. Best, Jerry

When’s the last time these saw action? …..might be time to open them up and do a complete service. Check and clean out the gear well, apply fresh grease, inspect the motors, clean & lubricate, inspect the trucks, clean & lubricate. Remember, the rule of thumb is if it moves or spins, it needs to be lubed!…… A good tune up sounds in order. Keep in mind, with Pulmor motors, they’re not going to run near as nice as any can motor would, but, you should get half decent performance out of them under TMCC…..

Pat

I think pat is onto the top suspect, some maintenance is called for after a long sleep, that's especially true for Pulmore motors.

As I mentioned they run pretty good on my cab 11L outfit but crappy on my LEGACY OUTFIT. Can I update my legacy outfit or what? I did clean up the engine but I did not take the cab off and the motors

Sorry I hit the wrong button. I will Lube the motors please advise again what I can do to my legacy control outfit. Much thanks, Jerry

@Jerry A posted:

Sorry I hit the wrong button. I will Lube the motors please advise again what I can do to my legacy control outfit. Much thanks, Jerry

Make sure you have your settings correct in your cab 2. So, hit info, and highlight the correct parameters. Use the dial to scroll through the selections. Select diesel, scroll and select TMCC, and finally, basic RS if so equipped. If you accidentally highlighted R100, the engine might not respond correctly to your commands…..

Pat

Thank you very much Pat. I will definitely try this. Again thank you, and have a Merry Christmas. Jerry