Skip to main content

Planning on building a ceiling/shelf around the room layout in my office.

I want a Big Boy, but the shelf size, in the corners, required for the Legacy (O72) is not what I want.

Does anyone have the LC2 BigBoy that's O31 capable? Specifically how much does the boiler overhang the outside of a curve? Pics would be great.

Original Post

Replies sorted oldest to newest

The LC+ 2.0 big boy has yet to ship but I do have a LM legacy big boy and should be the same tooling. I’d highly recommend nothing smaller than 0-36. I’ll try to get pics when I get home but as far as I remember the most likely spot that would hit is the rear engine cylinders. Witch from memory will stick out roughly an 1” from the side of the boiler. If just guessing I’d say the front of the boiler is again about an inch from the outside rail

Hope this helps

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×