I have a brand new never used IR and when i apply power the green light does not come on, and there is no power to the rails, any suggestions will be appreciated. I have three of these units non power up???It is the pre 2001 model, it is a lock on type with a power cable from a 1000 watt transformer. all three are this type
Your pictures attached from your previous post from the above quote.
Again, this type is the non-DCS and non "digital" version,it is not a 50-1033.
This is the original IR controller that is for conventional control only, it varies the AC voltage on the track and can provide a DC offset signal for traditional Bell and Whistle/Horn commands.
AC voltage from one of the MTH Z series bricks (Z500, Z1000, unsure about the Z750 21V brick??) must go into the round power jack, and then via IR command from the matching remote, you can raise track power from 0V upwards using the remote.
It will not work in "passive" mode by supplying power into the lockon connection.