Skip to main content

Inadvertently pushed e-stop button on remote.  Reset TIU, reset remote, added engine.  Results some functionality but not all.  Most critically unable to set any sequence under directional control, f/r, r/f, f/f etc.  nothing - when i try to select nothing happens- the selection does not highlight.  As a result (I guess) thumb wheel has no functionality re speed.  SMPH does not even show.  Other stuff, start-up, shut down, volume etc ok

Original Post

Replies sorted oldest to newest

Pat Coil posted:

Reset TIU, reset remote, added engine.  

What are you saying exactly by added engine? It seems you're saying that after the event, you tried to add a new engine to the remote, correct?

If a new engine didn't add fully, I would delete it and then re-add it. Make sure the DCS signal is strong where you add the engine on the layout. Remove other stuff that might effect the signal.

 This new engine might be scrambled. Try running it in conventional without the TIU signal to the track.

Add Reply

Post
The DCS Forum is sponsored by
×
×
×
×
Link copied to your clipboard.
×
×