Skip to main content

This is a problem that has just recently started. To run my conventional locos with my TPC 300, I use cab 1 mode and TR1 (which is how I programmed the TPC unit). Sometimes it jumps out of the cab 1 mode. When I press TR1, it does not go back to cab 1. How do I get it to stay in cab 1? I currently press info, clear the lashup, even though there is none, then I can go back to cab 1. However, the problem will recur within a few minutes. There must be a way to get it to stay in cab 1?

Original Post

Replies sorted oldest to newest

I use three TPC's on my layout, each programmed using the standart TMCC method, finished of with the push of the "set' button. To activate it for conventional mode press tr 1,or 2, etc and them the M button (momentum) which puts the TPC in conventional mode. Twist the red dial and the direction control and you should be in business.

Post
×
×
×
×
Link copied to your clipboard.
×
×