Last week this engine quit on me. I ordered up a new R4LC for my AC Commander and installed it today. I get 14V on the out put for the headlite but zero voltage for the smoke output. Is it possible the Commander board is bad???? It will run in conventional so the motor wiring is correct. Anyone have any thoughts on this??
Thanks,
Marty
Replies sorted oldest to newest
What version is the R4LC?
It should be "08" for ERR boards
It is an 08...
Thanks Marty
Marty, Do you have the smoke turned on in command mode?
Ray
SSmoke operates in Command mode. Head lite is hot wired, could not get it to light up connected to Command board. Engine runs just fine and I can control the smoke....
Marty
Access to this requires an OGR Forum Supporting Membership
