Skip to main content

Here is my question. I am going to finally dump my ZW-C postwar celebration version. It would not work with the Cab-1L. I needed a new chip which I purchased and tried to install. Dumb move on my part. I do not run any conventional locomotive anymore nor have I for years so I am finally going to use the TMCC direct lock on. I have four separate loops so I think I will need four of them. Do I need to run a separate wire from my current Cab 1 or Cab 1L base to each loop or will the current connection I have from the Cab 1 base still work fine? 

 Thanks in advance.

    Phil 

Original Post

Replies sorted oldest to newest

Shame with your ZW-C issues.  I bought the 180W version and love it, works great with my TMCC command base and Cab-1s.  And you did have the Base connected to one of the ground posts of the ZW, right?

 

Anywho, as far as the TMCC lockon, as long as the outside rails of the loops are connected, you will only need to attach the base to one of the lockons.  If they are completely separate, as in there is no common ground between the loops, you will need a signal wire for each loop.

Post
×
×
×
×
Link copied to your clipboard.
×
×